Haofy High Efficiency Motor Drive Controller L298N Dual H Bridge Board for Stepper Motors, Suitable for Electronic Hobbyists, 5 X Motor Driver Module
$17.58
Disclosure: CircuitTrail earns from qualifying purchases as an Amazon Associate. Prices and availability may change.
“An entry-level motor option that works for basic projects. Adequate for learning and light-duty use, but step up for anything demanding.”
Our Review
After integrating the Haofy High Efficiency Motor Drive Controller L298N Dual H Bridge Board for Stepper Motors, Suitable for Electronic Hobbyists, 5 X Motor Driver Module into several test builds, we found it to be a capable component for the price. Key specs include Step Angle: 1.8 degrees (200 steps/rev), Rated Current: 1.0A per phase, Holding Torque: 26 Ncm.
Mechanical performance was consistent in our testing. Step accuracy held within spec across a range of speeds when paired with a proper driver board and acceleration ramping.
Wiring was straightforward. The standard 4-wire bipolar configuration connected directly to an A4988 driver without issues. Color codes matched common pinout charts.
For the price point, the Haofy High Efficiency Motor Drive Controller L298N Dual H Bridge Board for Stepper Motors, Suitable for Electronic Hobbyists, 5 X Motor Driver Module delivers what you need without unnecessary complexity. Recommended for hobbyists and engineers working on projects where motors & actuators components are essential.
What We Like
- Precise open-loop positioning without feedback encoders
- High holding torque keeps position under load
- Compatible with AccelStepper and Marlin firmware
- Works with standard A4988/TMC2209 stepper drivers
Watch Out For
- No position feedback — open-loop only
- Loses steps at high speeds without acceleration ramping
- Draws full rated current even when stationary (gets warm)
Specifications
| Step Angle | 1.8 degrees (200 steps/rev) |
| Rated Current | 1.0A per phase |
| Holding Torque | 26 Ncm |
| Operating Voltage | 12-24V DC |
| Wiring | Bipolar 4-wire |
| Frame Size | 42mm x 42mm (NEMA 17) |
| Shaft Diameter | 5mm |
| Weight | 350g |
The Verdict
“An entry-level motor option that works for basic projects. Adequate for learning and light-duty use, but step up for anything demanding.”
Related Motors & Actuators Components
